Your water heater is one pretty used and much more costly appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving around the home heating and costs.
Regular flushing of one’s water heater is probably the single most important step you get to prolong its service life and to save energy. For time, sediments strengthen in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not merely destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most areas of the country, the average water heater lasts 3-5 years. Regularly flushing your water heater can double existence of your hot water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is in today’s affordable. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs in half. Depending on the volume of hot water your home uses, that can mean a savings of $20 to over $50 a nights.
To drain your water heater, on the internet should set the thermostat to pilot (if it is often a gas water heater) or turn the circuit breaker off (if it is an electric heater). Failure to do so could result in overheating and severe damage to the water heater. Next, close the water supply valve located more than a water inlet line going into your water heater. Then you’re connect a garden hose to the drain valve located at the base of the hot water heater. Open the drain and allow it to function until all for the water has emptied from the heating unit. Then close the drain. Open the water supply valve and refill the heating. You should also open a hot water faucet somewhere indoors and stand there and watch it run for several minutes until water flows out perfectly. This will allow air to vent because of the heater and the hot water lines. Finally, you can turn the thermostat to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your property to filter or condition the water so it is less corrosive to your plumbing system, particularly in areas which have hard this type of water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in place to discuss options and merchandise to be fitting.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610